Please observe the steps under to disassemble the Q0 Mini 8K Motion Key and discover the reset button if you have to flash the firmware.
Step 1: Take away the keycap of the Q0 Mini 8K Motion Key
Maintain the bottom with one hand and the keycap with the opposite, then pull it upwards to take away the keycap.
Step 2: Disassemble the swap and the bottom. Please observe the detailed steps under.
1. Peel off the silicone backside pad.
2. Put together a screwdriver, and switch it counterclockwise to take away the 2 screws within the base’s backside.
3. Disassemble the swap：
- (The switches on either side have clips.) Press down on the clip on one facet of the swap together with your finger, then use your finger or a instrument to pry that facet out.
- Maintain that facet in place, then pull out the opposite facet to completely take away the swap.
(Click on to play the video under.)
4. You can see the reset button on the nook of the PCB within the swap’s backside.
Step 3: To reinstall the swap and base, align the Kind-C port of the swap with the slot inside the bottom, and press the swap firmly into place. Then, safe the underside screws and reattach the feetpad. (Click on to play the video under.)
